Applications

Click on a job story below to read more.
SUBMIT YOUR STORY
Diaphragm Life

Diaphragm Life

Problem: A major international chemical company in New Jersey uses 3” air operated double diaphragm (AODD) pumps with PTFE diaphragms to pump a highly aggressive chemical through candle filters from an overhead tank. Part of the filtered chemical is recirculated at 30 psi back to the pump’s inlet. Rapid diaphragm failure was occurring in the AODD pumps. These pumps are generally limited to a maximum inlet pressure of 10 psi when equipped with PTFE diaphragms. As a result of the excessive inlet pressure, the PTFE diaphragms in these pumps lasted only a few hours.

Power Plant

Power Plant

Problem: A 300 megawatt power plant required a chemical feed system to supply hydrazine to a boiler. The hydrazine acts as an oxygen scavenger, and must be delivered in a precise and consistent quantity. While metering pumps can deliver chemicals in precise amounts, their reciprocating action will not allow delivery in a smooth and consistent flow.

Chronic Pulsation Issues at Power Plant in Central PA

Chronic Pulsation Issues at Power Plant in Central PA

Problem: The facility experienced persistent pulsation and vibration in a process line operating with two pumps. Operators noted:

- Poor pulsation control
- Unstable pressure readings
- Concerns that the dampener was “not working”
- Consideration of taking the dampener offline


Initial discussions suggested potential equipment malfunction. However, system layout and installation practices had not yet been fully evaluated.

During the site visit, the system configuration was reviewed in detail. Two critical issues were identified:

1. One Dampener Serving Two Pumps
Both pumps were discharging into a single pulsation dampener—an arrangement not suitable for proper attenuation or balanced operation.

2. Improper Dampener Placement
The dampener was installed well outside the recommended 10 pipe diameters from the pump discharge. At this distance, the unit could not effectively mitigate pressure fluctuations.

These conditions explained the apparent performance issues despite the dampener itself being fully functional.

Waste Liquids

Waste Liquids

Problem: A large manufacturing plant located in Japan uses air operated high pressure injection pumps throughout their plant to pump out waste liquids from reactor vessels. The reciprocating action of the pumps creates a pulsating flow which vibrates the plumbing, producing loud noise resulting in worker complaints and possible safety issues.

Descaling

Descaling

Problem: Rocky Mountain Steel Mills in Pueblo, CO uses two Myers/Aplex MA-240M quintuplex 200 HP plunger pumps to descale the raw material before it is sent through the forming rollers that create the final product. Each of these pumps produces 100 GPM at 2,200 psi. The reciprocating action and high pressure created by these pumps causes severe shaking of the pipes, valves, and pipe supports in the system. More critical to the operation, the pulsating flow can cause erratic descaling of the raw material. This erratic descaling can cause damage to the form rollers and can make it difficult for the steel mill to achieve consistent quality in their final product. This style of pump also requires a smooth flow of fluid to the inlet to work properly.

Advanced Materials Facility

Advanced Materials Facility

Problem: An advanced materials facility based in the Greater Toronto Area was hesitant to include dampeners in their operation as they hadn't had luck with them previously. Blacoh asked to see the installation. Upon further investigation, we discovered the customer had one uncharged dampener for two pumps (photo below), and it was located well outside the recommended 10 pipe diameter rule. This is a prime example of the importance of Size, Location, and Charge in regards to dampener installation.